Форум
Вы не залогiненi!      [ Увiйти ]  |  [ Реєстрацiя ]
Форум » Лазерна обробка матеріалів » Тема: is ordering laser-cut steel as easy as ordering PCBs? -- Сторiнка 1  Перейти в: 

Вiдправник Повiдомлення
JohnHale JohnHale
Зареєстрований користувач




з: USA
Повiдомлення: 17

 is ordering laser-cut steel as easy as ordering PCBs?
Вiдправлений: 03-05-2018 10:25
Hi,

I would like to modify some of the liteplacer's metal plates... add a few extra holes for running cables, mountpoints for lasers, a PCB, and more cameras, and extend the mounting-post for the X-dragchain to provide support (the plastic dragchains aren't meant to hold themselves in the air, the joints are not strong enough and mine have buckled backwards). Most of these require enlarging the plates rather than drilling additional holes, and I'd like to keep the original parts in case I screw up.
Can laser-cut metal parts like those in the liteplacer be ordered in small quantities easily, like PCBs, or do you need to buy 100 of them in order to get a supplier's attention?
If so, can anybody recommend a good supplier for a very small run?

Any help will be apprecited.

I didn't find the right solution from the Internet.

References:
https://liteplacer.com/phpBB/viewtopic.php?f=4&t=140
3D Walkthrough Video

Thank you.

Вiдповiсти
Заголовок:
Iмя:
E-Mail:


Текст:
Смайли:
Додатковi смайли
Опцiї:
Присилати вiдповiдi на це повiдомлення на Ваш e-mail
Введiть код:

Статистика

Зараз користувачiв на форумi: 2 Гостi
Всього повiдомлень: 329
Всього тем: 81
Зареєстровано користувачiв: 107
Сторiнка сгенерована за: 0.008 секунд

Счетчик тИЦ и PR
Copyright © 2019 7910 e-commerce